By: Brad Burt - RedHouse

FV3_PCB.pdf
To download the Forum-Vibe PCB layout files, you must now submit a request using this web-form and the file you are requesting will be emailed to you normally within 24 hours.

PowerBoards.pdf
PDF with two small power boards, one for a LM317 and one for a 78xx regulator, either can be used with the Forum-Vibe.

New Updates and Corrections 2011

• New online documentation and modified PCB layout (v3)
• New proceedure for downloading key Forum-Vibe PCB layout files
• New Bias Offset tweak option on v3 board
• Trimmer solder pads revised again
• New PDF added with two small power regulator boards PowerBoards.pdf
• Correction to Multi-Vibe Mod diagram, C11 and C14 were shown wrongly in upper diagram
• New Terms Of Use webpage explicitly defining my Forum-Vibe's terms of use.
• ForumVibe2.pdf has been retired, Forum-Vibe documentation is now online.
  (there will be no further FormVibe.pdf documenation files)

Old Updates and Corrections: Forumvibe.pdf & Forumvibe2.pdf

• File re-worked from Photoshop to Illustrator to decrease file size.
• File renamed to ForumVibe2.pdf to differenciate it from the original file
• Latest PCB can be identified by a 2 above the R4-F designation.
• The pads for trimpots were changed.
• Jumper J5 has been removed, it was a "mod" nobody cared about (including me) so it's gone.
• Page-6 had the part designations for TR2 & TR3 and R39 & R40 reveresed in the diagram.
• References to the Q10/C14 connection issue have been removed.
• Polarity was incorrectly shown on C1, C2, C3, C5.
• C11 was shown as a .047uF (should have been 470pF).
• Alternate bias link (lower picture) was shown shorting bulb
• Light cover solder-pad size increased slightly

<<  Back